Large Diaphragm Tube Condenser – SATIN NICKEL
The MA-200 is a large diaphragm, vacuum tube condenser microphone with a fixed cardioid pattern. Born to a lineage of fine microphone designs by David Royer, the MA-200 gives warm, full-bodied reproductions of vocals and instruments, with none of the shrillness and high frequency distortion artifacts that are often encountered with modern condenser microphones.
Utilizing hand-selected 3-micron capsules, high-quality Jensen audio transformers and military-grade JAN 5840 vacuum tubes, the MA-200 performs at a level reminiscent of some of the best-loved classic condenser microphones. The MA-200 power supply can be set for 115V and 230V, 50 or 60 Hz, through an internal switch (100V is also available). Each MA-200 microphone, power supply and cable set is burned in for 24 hours, carefully tested and evaluated, then packaged in its protective case-within-a-case.
Features :
- Hand-selected 3-micron capsule
Jensen audio transformer
Military grade JAN 5840 vacuum tube
Internal switchable power supply voltage
Ultra clean signal path Recommended Applications : - Use anywhere you would use an expensive, large diaphragm tube microphone. Vocals
Voice Over and Broadcast
Acoustic Instruments
Piano
Drum Overheads, Drum Rooms
Orchestral Recording
Choral Recording TECHNICAL DATA
TRANSDUCER TYPE: Externally excited capacitor type
DIAPHRAGM: 1-inch diameter, gold sputtered
DIAPHRAGM THICKNESS : 3-microns
POLAR RESPONSE: Cardioid
FREQUENCY RESPONSE: 20 Hz – 20 kHz, +/-3dB
SENSITIVITY: -37dB re 1V/pa
MAXIMUM SPL: 120dB
DISTORTION: head amp only, <1% @117dB SPL, <3% @ 125dB SPL
SELF NOISE: 14db nominal, not to exceed 16db (A Weighted)
IMPEDANCE: 200 ohms, balanced using an output transformer
VACUUM TUBE: 5840 – pentode tube wired for triode operation
POWER REQUIREMENTS: 100-120VAC; 220-240VAC, 50 or 60 Hz. Power consumption approx. 10 watts.
DIMENSIONS AND WEIGHT:
Carrying case with microphone, power supply, shock mount
and cables: 13 lbs.
Microphone: 7 5/8″ X 2″, 1 lb.